Spray glue indispensable for floristry and decoration.For gluing floral materials, use our tried-and-tested OASIS® Floral Adhesive as before.Hazard statements:Extremely flammable aerosol. Pressurised container: May burst if heated. Causes serious eye irritation.Precautionary statements :If medical advice is needed, have product container or label at hand. Keep out of reach of children. Read carefully and follow all instructions. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Avoid release to the environment. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Protect from sunlight. Do not expose to temperatures exceeding 50 °C/ 122 °F.Additional information:Without adequate ventilation, explosive atmosphere/gas mix may be created. Warning! Hazardous respirable droplets may be formed when sprayed. Do not breathe spray or mist. Dispose of contents/ container in accordance with local/regional/national/international regulations.

Pins with green plastic carrier. The different center of gravity makes it easy to work with large flowers. For corsages at weddings and other festive occasions.The low center of gravity prevents tipping. Flowers and petals can be fixed particularly well with OASIS® Floral Adhesive. Spray the finished corsage with OASIS® Clear Life for longer durability.TIP: Flowers and petals can be fixed particularly well with OASIS® Floral Adhesive.

Pins with green plastic carrier. The different center of gravity makes it easy to work with large flowers. For corsages at weddings and other festive occasions.The low center of gravity prevents tipping. Flowers and petals can be fixed particularly well with OASIS® Floral Adhesive. Spray the finished corsage with OASIS® Clear Life for longer durability.TIP: Flowers and petals can be fixed particularly well with OASIS® Floral Adhesive.

The mini vacuum suction cup made of transparent plastic was specially developed for products with the Easy-Click system: It is used to fix flower arrangements with OASIS® ECObase® hearts and the OASIS® ECObase® cross to smooth surfaces such as glass, mirrors, gravestones or car hoods (for vehicles with standard car paint).Attaching the vacuum suction cup to the products:Press the suction cup into the receptacle (plastic-lined recess in the hard foam base of the above-mentioned products) until it snaps into place. The round thickening at the top of the suction cup prevents the suction cup from detaching from the foam base.Fixing the arrangement to the intended base:Please first clean and dry the suction surface of the vacuum suction cup and the intended base. These must be clean, dry and free of grease, otherwise the holding power of the vacuum suction cup cannot be guaranteed. For example, freshly polished car paint can impair the holding power of the vacuum suction cup. In this case, the polish should be carefully removed from the corresponding area with warm water, detergent and a lint-free cloth.Removing the arrangement from the base:Use your fingertip to lift the suction surface of the vacuum cup slightly at the edge and allow air to flow into the existing vacuum. The vacuum suction cup will now detach from the base and the arrangement can be removed.

Suitable for fresh and dried flowers. Adheres securely to glass, ceramics, wood, ribbons, etc. Sticks without damaging delicate leaf structures. This means a secure hold without staining leaves and flowers.OASIS® Floral Adhesive always remains invisible in places where you don't want the adhesive to be visible.

Ideal aid for attaching OASIS® ECObase, Foam Frames™ Products, e.g. to the car hood using OASIS® Pin Holders. Also for smooth surfaces such as glass, aluminum and steel plates. Can be removed without leaving any residue.

Optimal for attaching Floral Foam to smooth surfaces (e.g. in pots) or candles. in pots) or candles on floral foam with the help of OASIS® Fix.Fixing floral foam to smooth surfaces:The surface should be clean and dry. Fix the pinholder with the flat side on the surface and press the Floral Foam onto the pins. Fixing candles on Floral Foam:Fix the candle on the plate of the pinholder, insert the pinholder with the tip into the foam.TIP: Always make sure that the surface is clean, dry and free of grease, as otherwise the adhesive strength of the holder may be impaired.

For attaching stick or candlestick candles in the floral foam of both OASIS® fresh and dried flower arrangements.TIP: The candle holder can be easily shortened with florist scissors. This means it can also be used for arrangements with a low foam height.

For attaching stick or candlestick candles in the floral foam of both OASIS® fresh and dried flower arrangements.TIP: The candle holder can be easily shortened with florist scissors. This means it can also be used for arrangements with a low foam height.

Optimal for attaching Floral Foam to smooth surfaces or for attaching candles to Floral Foam.Fixing Floral Foam to smooth surfaces:The surface should be clean and dry. Place the flat side of the fixing pin on the surface and press the Floral Foam onto the pin. For Pini-Extra, use OASIS® Fix adhesive (article no. 31-06010) to help.Fixing candles to Floral Foam:Press the candle onto the flat part of Pini-Extra, insert the fixing pin into the foam with the tip facing downwards.TIP: Always make sure that the surface is clean, dry and free of grease, as otherwise the adhesive strength of the holder may be impaired.

The vacuum suction cup made of green plastic was specially developed for floristry requirements. It is used to fix flower arrangements (e.g. rings, hearts, garlands, etc.) to smooth surfaces such as glass, mirrors or car bonnets (for all standard car paintwork). The flower arrangement can be easily attached to the suction cup with the help of two fastening eyelets, ensuring a secure hold.Application:The surface on which the mini suction cup is to be placed must be smooth, clean and grease-free (freshly polished car paintwork can impair the suction cup's holding power).Place the decoration in the desired locationPosition the DECO-FIX suction cup close to the arrangementConnect the arrangement and DECO-FIX at the most stable point

Ideally suited for attaching Floral Foam to smooth surfaces or for attaching candles to Floral Foam.Fastening Floral Foam to smooth surfaces:The surface should be clean and dry. Fix the fixing pin to the surface with the flat side and press the foam onto the pin.Attaching candles to Floral Foam:Press the candle onto the flat part of Pini-Extra, insert the fixing pin into the foam with the tip pointing downwards.TIPP: In any case, make sure that the surface is clean, dry and free of grease, otherwise the adhesive strength of the holders may be impaired.

Optimal for attaching floral foam to smooth surfaces or for attaching candles to floral foam.Fixing Floral Foam to smooth surfaces:The surface should be clean and dry. Fix the fixing pin with the flat side on the surface and press the Floral Foam onto the pin.Fixing candles to Floral Foam:Press the candle onto the flat part of Pini-Extra, push the insert the fixing pin into the foam with the tip facing downwards.TIP: In any case, make sure that the surface is clean, dry and free of grease, otherwise the adhesive strength of the holder may be impaired.

For attaching flower arrangements to all smooth surfaces. The transparent EASY-Vac has an extra large suction surface. Both wire and string can be fed through the hole in the upper part to securely fasten the workpiece.Please note:Both the suction cup plate and the base (e.g. car hood) must be clean, dry and free of grease, otherwise the holding power of the vacuum suction cup cannot be guaranteed. For example, freshly polished car paint can impair the holding power of the vacuum cleaner. In this case, the polish should be carefully removed from the relevant area with warm water, washing-up liquid and a lint-free cloth.The arrangement can be easily removed from the base by lifting the suction cup plate slightly at the edge with your fingertip. This allows air to flow into the vacuum and the suction cup detaches easily from the base.

Knead the desired amount (approx. 3 cm is usually sufficient) into a small spheres and press onto the plate-shaped part of the Pinholder or Pini-Extra. Then heat briefly over an open fire (e.g. lighter), this increases the adhesive strength. If you want to use OASIS® Fix with floral foam in containers, you should make sure that the container surface is dry and clean. If you want to attach candles to the floral foam, you should pre-treat the candles: The candles have an immersion layer, which is also the color layer. This layer should definitely be removed from the base of the candle, as otherwise optimum adhesion is not guaranteed.CAUTION: Do not apply to car paint! Store at room temperature. The adhesive can be easily removed from ceramics with hot water.

For attaching or additionally securing fresh and dried floral foam to flat surfaces.

For attaching smaller accessories (e.g. greeting cards) to almost all materials: ceramic, glass, plastic, metal, wood, paper and plants. The surface on which the accessory is to be placed must be dust-free. Pull out the backing strip on which the adhesive dots are located until the required amount of adhesive dots is visible. Press the back of the accessory onto the adhesive dot. The adhesive dot will now adhere to the back when you lift it off. The accessory can then be attached to the desired location by lightly pressing it on.Attention: Frost can impair the holding power of the adhesive dots.Note for first use:The first meter of the carrier tape does not contain any adhesive dots. It serves as protection against the adhesive dots drying out during prolonged storage.

Das transparente Klebeband ist optimal geeinget zum sicheren und professionellen Verpacken. Es lässt sich leicht abrollen und ist auf der fertigen Verpackung kaum sichtbar.

Das transparente Klebeband ist optimal geeinget zum sicheren und professionellen Verpacken. Es lässt sich leicht abrollen und ist auf der fertigen Verpackung kaum sichtbar.

For easy handling of adhesive tape when wrapping or rewrapping bouquets.

This double-sided self-adhesive tape enables materials to be attached quickly and almost invisibly to various materials. It can be used, for example, to quickly and easily cover a container with decorative fabric or other decorative materials.

This double-sided self-adhesive tape enables materials to be attached quickly and almost invisibly to various materials. It can be used, for example, to quickly and easily cover a container with decorative fabric or other decorative materials.

For mounting decorations.Suitable for hot glue gun NT, 120°C NT, 80 Watt.

For attaching or additionally securing fresh and dried floral foam to flat surfaces.